Dell PowerEdge R320

This page desperately needs to be filled out or brought up to date. If you're familiar with the operations of this part of the site, please help!

BIOS settings

The following settings should normally be changed from the defaults & MUST BE CHANGED VIA PHYSICAL CONSOLE:

• The bios controller on iDRAC7 is very different than the previous versions
• During initial boot and from the Physical Console press F2 to enter BIOS settings
• A Dell Main Menu GUI will appear and offer 3 options (You can either use the mouse or TAB key)

 - System BIOS
 - iDRAC Settings
 - Device Settings

• Required System BIOS Setting Changes

 * Under Processor Settings 
   - Disable Logical Processor 
   - Disable Virtualization Technology
 * Under Serial Communications
    - Change Serial Communication setting to: "On with console redirection via com2" 
    - Change Serial Port Address to: "Serial Device1=COM1, Serial Device2=COM2"
    - Disable Redirection after reboot
 * Save and Exit and go back to main menu

• Required iDRAC Settings

 * Under Network 
    - Change the IPv4 Information; (Management, Gateway, Subnet)
* Under User Configuration
   - Change root password

• Save and Exit to go back to Main Menu

Obtaining MAC Address

• During initial BOOT, press F2
• At Main Menu enter "Device Settings"
• Click on NIC1

RAID Controller Changes

• During initial BOOT, press F2
• At Main Menu enter "Device Settings"
• Click on RAID Controller